The raspberrypi themselves didnt get it working yet. OctoPrint provided by Prusa Research is tested and is confirmed to be booting correctly. It will not work because the Pi Zero W was released after 0.13. If the Octoprint webpage loads, you can continue. A raspberry pi zero W is very attractive, but it is right on the edge of working. If octopi.local doesn't work, please use the following steps: Check your router for a new IP address, using an app like Fing, or wait until the address is displayed on the printer's display.Īs soon as you have the IP, open a web browser on your PC, type it in, and hit Enter. Then open the browser and try opening a website: octopi.local. The RPi Zero is not a superfast computer and it needs time to boot. Go to the printer's LCD menu -> Settings -> RPi port, and make sure it is set to ON. The web server for Octoprint took forever to load (and refresh).

Notice that the position of the support pin is in the corner ( purple arrow). Tried using the 32 and 64 bit versions with the PI Zero 2 W and just had a ton of issues. The power LED will light on the Pi Zero indicating it is reading the operating system from the SD card and loading. Now plug the power into the Micro USB 5V Power connector on the Pi Zero. 3 and 3 B+, Pi 2, and even the Zero/Zero W. Eject the SD card from your computer and insert it into the MicroSD card slot on the Raspberry Pi Zero as shown in the picture below.

Make sure the RPi Zero is properly installed by inspecting the connector on the other side of the Einsy Rambo ( green arrows). RISC OS Pi brings an alternative desktop environment and a stack of heavily.

Pi zero w octopi